Installation of the Bathroom Gem Floor Toilet

Installing the Bathroom Gem Floor Toilet is a very easy process, similar to installing any conventional toilet.  Your plumber should have all the tools, equipment and knowledge necessary for a successful installation.

Step 1: Location Selection

The first step is selecting a convenient location for the floor toilet that is easily accessible to an individual who uses a wheelchair.  The location should be within 10 feet of a cold water supply (such as the cold water supply for a sink or conventional toilet), and within 5 feet of a drain line (either the home's drainage system or a conventional toilet).

Step 2: Prepare Floor Position

Locate the position on the floor to install the toilet.  The unit will fit between the floor joists in most homes with a wood floor.  Cut a 14 3/8" by 16" hole in the wood floor.

Step 3: Fit Toilet into Hole

Fit the floor toilet into the hole and attach with the supplied wood screws.

Step 4: Attach to Cold Water Supply

Locate the cold water supply source.  If located in the wall, drill a hole to expose access to the line.  Attach a 3/8" T-connector to the cold water supply line (or attach to the cold water supply line of a sink or conventional toilet).

Step 5: Attach to Drain

Locate the waste line connection, either directly into the toilet (using the clip to attach to the toilet bowl) or into the drain line at the most convenient location.

Step 6: Connect to Power Supply

Plug the 110-volt GFI plug into any grounded power outlet.

Your new Bathroom Gem Floor Toilet is now ready for use.