Installation of the Bathroom Gem Wedge Toilet

Installing the Bathroom Gem Wedge Toilet is a very easy process.  Your plumber should have all the tools, equipment and knowledge necessary for a successful installation.

Step 1: Location Selection

The first step is selecting a convenient location for the floor toilet that is easily accessible to an individual who uses a wheelchair.  The location should be within 10 feet of a cold water supply (such as the cold water supply for a sink or conventional toilet), and within 5 feet of a drain line (either the home's drainage system or a conventional toilet).

Step 2: Attach to Cold Water Supply

Locate the cold water supply source.  If located in the wall, drill a hole to expose access to the line.  Attach a 3/8" T-connector to the cold water supply line (or attach to the cold water supply line of a sink or conventional toilet).

Step 3: Attach to Drain

Locate the waste line connection, either directly into the toilet (using the clip to attach to the toilet bowl) or into the drain line at the most convenient location.

Step 4: Attach Side Ramp

Determine if the bag release is on the left or right foot side for the individual who will be using the toilet.  Attach the side ramp unit on either the left or right side as is appropriate.

Step 5: Attach Side Rails

Attach the side rails (toe kick) units to both sides of the toilet.

Step 6: Attach Front Ramp

Attach the front ramp unit to the toilet.

Step 7: Position and Secure the Toilet

Slide the toilet so it is flush to the wall at the desired location.  Anchor both sides of the toilet securely to the floor.

Step 8: Connect to Power Supply

Plug the 110-volt GFI plug into any grounded power outlet.

Your new Bathroom Gem Wedge Toilet is now ready for use.